Instructions for use _ homba baby

INSTRUCTIONS MANUAL _ homba baby (EN)

The Homba baby cradle will quickly soothe your baby and give him a good night's sleep during the day. The spring has a load capacity of <15kg a zabezpečuje rytmické hojdanie (hore – dole). Hojdanie podobné tomu, ktoré bábätko zažívalo v brušku mamičky v priebehu tehotenstva. Bábätku hojdanie navodzuje príjemné pocity.

The baby in the cradle lies in a position called. "gags." The back is slightly arched into a round and the legs are bent towards the body. This is how most physiotherapists recommend wearing the baby. This promotes the proper development of the spine and also relieves colic. Slight elevation of the cradle at the baby's head prevents reflux, which can be especially pronounced in the first 6 months. Thanks to the cradle, the baby actively relaxes, falls asleep easily and you can spend less time putting him to sleep and have more time to relax, yourself and the rest of the family.

PURPOSE OF USE

The Homba baby textile hanging cradle is used for rocking, putting to sleep, lying down and sleeping babies from 0 to about 10 months (does not replace a cot). The maximum load capacity of the spring is <15kg.

Use of the cradle in ways and conditions other than those specified in the instructions is prohibited!

SAFETY WARNING

• Read the instruction manual carefully and use the product according to the instructions given - any modifications and changes to the product that adversely affect health and safety are prohibited. Do not hang the cradle near a fire or other heat sources.
• Before 1. wash the cradle according to the instructions.
• Don't leave baby unsupervised - from the moment baby is able to sit up or turn around in the cradle on his/her own, the cradle should only be used in the immediate presence of an adult. The manufacturer is not liable for any accidents. The cradle is not intended for playing.
• Do not exceed the permissible load capacity of <15 kg - there is a risk of spring deformation or breakage.
• Check the safety rope regularly - IT MUST PASS THROUGH THE TOP LINK, THROUGH THE WIRE AND THROUGH THE BOTTOM CARABINER. ADJUST ITS LENGTH SO THAT WHEELS REMAIN HANGING ABOVE THE GROUND WHILE DISTURBING THE WHEELS, so that you can swing comfortably.
• Check the condition of the used rope regularly - it must be in perfect condition, there must be no mechanical wear. If even minimal damage is found, replace the rope immediately!
• Regularly check the strength of the hanging method - bolt in the ceiling, intermediate trapeze, separate rack. Place the cradle only in places that can safely support the load. Beware of plasterboard ceilings or other cladding. In this case, always consult a specialist for suspension. Check the strength of the bolts and brackets by a load test using your own weight.
• Packaging - Plastic bags and other packaging must be kept out of the reach of children under 3 years of age after unpacking the product.

PACKAGE CONTENTS

1. Textile hanging cradle
2. Spring mattress
3. Mattress wrap
4. Wooden oak divider
5. Spring
6. Spring wrap
7. Carabine
8. Coupling link
9. Safety rope - 2m
10. Suspension rope - 2m
11. Textile bag with zipper

WHEEL STORAGE

 

Spring assembly and attachment

 

Take the spring and check that

the safety cable passes through the connecting

the link - through the spring - through the carabiner.

The safety rope is tied with a figure-of-eight counter knot.

The length of the rope must allow comfortable swinging and at the same time

must not drop the cradle to the ground in the event of

destruction of the spring. Finally, check

the strength of the knot (a counter-rotating figure-of-eight knot).

Insert the connecting link (clip) into

prepared suspension method

(on the ceiling, in a rack) and screw it in, or use a suspension rope - 2m, which you tie to the necessary length with an eight-pointed counter knot .

 

1. Insertion of cradle

Take the fabric cradle

and at the point of the top fold, gradually thread the fabric

so that you can insert it

into the carabiner. Then close the carabiner.

Place the baby in a cloth bag

from the side where the rivets are on the cradle for unfastening.

Unzip these for the purpose of

inserting the baby.

 

Inserting the mattress into the cradle

Insert the mattress (buckwheat pods up) into the suspended cradle up to the top (back) edge of the Homba baby fabric cradle.

Foundation of wooden strut

Sides of textile cradle Bring baby up and insert into the grooves of the wooden spacer (trapeze) approximately 10cm from the top insertion into the carabiner.

Putting the baby in the cradle

Insert the baby so that the baby's head is at the top edge. This will ensure that the header is slightly raised. After inserting the baby, fasten the rivets on the front of the cradle. When the baby is inside the bag, the rivets must always be fastened.

Osmic counter node

The spring must always be secured with a safety rope that is tied through the spring, clip, carabiner and tied with a counter-rotating figure-eight knot. The rope needs to be checked at all times to make sure it is in order and secures the spring. If the rope shows signs of damage, it must be replaced immediately.

1. LET'S HANG ON
2. CONNECTING ARTICLE (SHRUBBING CARABINET)
3. BAG (Load capacity up to 15kg)
4. CARABIN
5. SAFETY ROPE 2M (IMPORTANT)
6. TEXTILE WHEELS
7. WOOD SPLITTER
8. MATTRESS COVER
9. MATRAC

MAINTENANCE

You can wash the textile bag at 40°C. The mattress cannot be washed, due to the embedded buckwheat pods. However, you can clean it with a damp cloth at the point of soiling. It must therefore be protected by the cover included in the package. The product lifetime is at least 2 years.

LIKVIDATION

Disposal of the product after irreparable damage or at the end of its useful life - the equipment must be disassembled and separated into its individual parts, components and materials, which will be disposed of in accordance with the legislation and regulations in force at the time of disposal.

Producer: MADlife LLC, website: www.homba.store